eLibrary >
ISO/IEC 25434:2008 Information technology - Data interchange on 120 mm and 80 mm optical disk using +R DL format - Capacity: 8,55 Gbytes and 2,66 Gbytes per side (recording speed up to 16X) >
Expand All
TOC Search:
ISO/IEC 25434:2008 Information technology - Data interchange on 120 mm and 80 mm optical disk using +R DL format - Capacity: 8,55 Gbytes and 2,66 Gbytes per side (recording speed up to 16X), 2008
- Scope
- Conformance [Go to Page]
- Normative references
- Terms and definitions
- Conventions and notations [Go to Page]
- Abbreviated terms
- General description of the optical disk
- General Requirements [Go to Page]
- Reference Drive [Go to Page]
- Dimensional characteristics [Go to Page]
- Mechanical characteristics [Go to Page]
- Optical characteristics in the Information Zone [Go to Page]
- Data format [Go to Page]
- Track format [Go to Page]
- General description of the Information Zone
- Layout of the Information Zone of a Single-session disk [Go to Page]
- Inner Drive Areas [Go to Page]
- Lead-in Zone [Go to Page]
- Data Zone
- Middle Zones [Go to Page]
- Outer Drive Areas [Go to Page]
- Lead-out Zone [Go to Page]
- Multi-session Layout [Go to Page]
- Sequential recording in Fragments [Go to Page]
- Assignment of Logical Sector Numbers (LSNs)
- Disk Control Blocks [Go to Page]
- General
- Method of testing [Go to Page]
- Characteristics of the groove signals [Go to Page]
- Method of testing [Go to Page]
- Characteristics of the recorded signals [Go to Page]
- Additional testing conditions [Go to Page]
- Quality of the recording layer [Go to Page]
- Method of testing [Go to Page]
- Minimum quality of a Recording Unit [Go to Page]
- B.1 Extended format information [Go to Page]
- C.1 Calibration method
- C.2 Measuring method
- D.1 Principle of the measurement
- D.2 Measurements conditions
- D.3 Example of a measurement set-up
- E.1 System diagram for jitter measurement and characterizati
- E.2 Open loop transfer function for PLL
- E.3 Slicer
- E.4 Conditions for measurement
- E.5 Measurement
- F.1 Measuring method for the differential phase tracking err
- F.2 Measurement of /T without time interval analyzer
- F.3 Calibration of the circuit [Go to Page]
- G.1 Pulsed write strategy
- G.2 Castle write strategy
- G.3 Rise and fall times
- I.1 Optimum writing power [Go to Page]
- K.1 Wavelength/Temperature behaviour of recorders
- K.2 Write power / Wavelength dependency of the disk [Go to Page]
- K.3 Determination of parameters for the Physical format info [Go to Page]
- L.1 Approximation of servo behavior [Go to Page]
- L.2 Considerations for practical measurements and practical [Go to Page]
- L.3 Example calculations for axial tracking [Go to Page]
- L.4 Example calculations for radial tracking [Go to Page]
- M.1 Relation between normalized wobble signal and wobble amp
- M.2 Tolerances of the normalized wobble signal
- O.1 General
- O.2 Packaging [Go to Page]