ASTM A1014/A1014M-06
Historical Standard: ASTM A1014/A1014M-06 Standard Specification for Precipitation-Hardening Bolting Material (UNS N07718) for High Temperature Service
SUPERSEDED (see Active link, below)
ASTM A1014 / A1014M
1. Scope
1.1 This specification covers a precipitation hardening bolting material (UNS N07718) for high temperature service.
1.2 This specification is expressed in both inch-pound and in SI units. However, unless the order specifies the applicable 'M' designation (SI units), the material shall be furnished to inch-pound units.
1.3 The values stated in either inch-pounds or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A962/A962M Specification for Common Requirements for Bolting Intended for Use at Any Temperature from Cryogenic to the Creep Range
B637 Specification for Precipitation-Hardening and Cold Worked Nickel Alloy Bars, Forgings, and Forging Stock for Moderate or High Temperature Service
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
E112 Test Methods for Determining Average Grain Size
E292 Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials
ASME Standards
B1.1 Screw ThreadsSAE Standards
AS7467 Bolts And Screws, Nickel Alloy, UNS N07718 Tensile Strength 185 KSI [1275 MPa] Stress Rupture Rated Procurement SpecificationKeywords
bolting; fasteners; Inconel 718; nickel alloy; precipitation hardening; temperature service application high; Nickel alloy bolting materials--specifications; Precipitation-hardening nickel alloy--specifications; UNS N07718 (Ni-Cr alloy, Inconel 718) ;
ICS Code
ICS Number Code 77.140.30 (Steels for pressure purposes)
DOI: 10.1520/A1014_A1014M-06
ASTM International is a member of CrossRef.
