ASTM D3774-96(2004)
Historical Standard: ASTM D3774-96(2004) Standard Test Methods for Width of Textile Fabric
SUPERSEDED (see Active link, below)
ASTM D3774
1. Scope
1.1 This test method covers the measurement of the width of fabrics, pile or napped surface width, or both. The method is applicable to full rolls, bolts of fabric, and short specimens removed from a roll or bolt. Unless otherwise specified, measurements shall include the selvages when present.
1.2 The method offers two options:
1.2.1 Option AFull Roll or Bolt.
1.2.2 Option BShort Specimen Removed from Full Roll or Bolt.
1.3 The values stated in either SI units or U.S. customary units are to be regarded as standard. The U.S. customary units may be approximate.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D1776 Practice for Conditioning and Testing Textiles
Other Standard
ANSI/ASQCZ1.4 by Attributes Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
Woven fabric; width. ;
ICS Code
ICS Number Code 59.080.30 (Textile fabrics)
DOI: 10.1520/D3774-96R04
ASTM International is a member of CrossRef.
