|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document describes an analytical method to determine the emissions from non-metallic materials used for moulded parts in motor vehicles, such as textiles, carpets, adhesives, sealing compounds, forms, leather, plastic parts, films and sheets, paints or material combinations. The materials are characterized in terms of the type and quantity of organic substances that can be outgassed from them. For this purpose, two semiquantitative sum values are determined, which allow an estimation of the emissions of volatile organic compounds (VOC value) and the proportion of condensable substances [low volatile “fogging” compound (FOG) value]. Furthermore, individual substances of the emission are determined. During the analysis, the samples are thermally extracted, the emissions are separated by gas chromatography and detected by mass spectrometry. The test method presented in this document provides values that are valid only for conditions described in this document. The results which can be achieved using this method are not appropriate for making further estimations of any kind of the health effects of emitted substances nor should they be used might that can be found in the interior of a complete vehicle in stationary condition, while driving or in conditions similar to driving. About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|