|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document specifies physical and performance requirements, test methods and marking requirements for industrial protective helmets. This document describes the requirements for two helmet types. Type I — intended to protect the upper part of wearer’s head against impacts that may occur in an industrial setting, such as a falling object. Type II — intended to protect the head against impacts that may occur in an industrial setting, such as a falling object or a fall. NOTE           The Type II helmet is intended to offer protection from falls from standing or a low height, e.g. standing height elevated by up to one metre. The Type II helmet is not intended to offer protection to the head in all falls and is unlikely to prevent serious head injury or death in uncontrolled falls from one level to another or from a position elevated on a ladder or scaffolding. The selection of a Type II helmet should be considered as one part of an overall safe system of work in the context of working at heights and managing the risks of falls from greater than two metres. The following editions for this book are also available...
About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|