|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document specifies procedures for measuring mechanical mobility and other frequency-response functions of structures excited by means of an impulsive force generated by an exciter which is not attached to the structure under test. It is applicable to the measurement of mobility, accelerance or dynamic compliance, either as a driving point measurement or as a transfer measurement, using impact excitation. Other excitation methods, such as step relaxation and transient random, lead to signal-processing requirements similar to those of impact data. However, such methods are outside the scope of this document because they involve the use of an exciter which is attached to the structure. The signal analysis methods covered are all based on the discrete Fourier transform (DFT), which is performed mostly by a fast Fourier transform (FFT) algorithm. This restriction in scope is based solely on the wide availability of equipment which implements these methods and on the large base of experience in using these methods. It is not intended to exclude the use of other methods currently under development. Impact excitation is also widely used to obtain uncalibrated frequency-response information. For example, a quick impact test which obtains approximate natural frequencies and mode shapes can be quite helpful in planning a random or sinusoidal test for accurate mobility measurements. These uses of impact excitation to obtain qualitative results can be a first stage for mobility measurements. This document is limited to the use of impact excitation techniques for making accurate mobility measurements. About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|