|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document establishes general rules for evaluating and expressing uncertainty in measurement from the shop floor to fundamental research. Therefore, the principles of this suite of documents are intended to be applicable to a broad spectrum of measurements and their applications. An overview of the parts of the GUM is given in table A.1 in Annex A. NOTE Where the acronym GUM is used in this document, it refers to the suite of documents. An individual part of the GUM is referred to by its corresponding JCGM numbering (e.g., part 6 of the GUM is JCGM GUM-6:2020). This document gives a rationale for evaluating, expressing and using measurement uncertainty (Clause 2). A brief introduction is given to measurement (Clause 3) and to the decisions involved when evaluating measurement uncertainty (Clause 4). In Clause 5, a brief description of the contents of the parts of the GUM is given. In each of these clauses, the relevant parts of the GUM are identified for further guidance. About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|