|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document specifies the fittings made from short glass fibre reinforced polyethylene (PE-sGF) manufactured by the spiral cross winding method used below ground for the conveyance of fluids in the following industrial and agricultural contexts: —    chemical plants; —    industrial sewerage engineering; —    power engineering (cooling and general-purpose water supply); —    agricultural production plants; —    water treatment; —    small hydraulic power plants (general-purpose water supply). This document also specifies the test parameters for the test methods it references. In conjunction with the other parts of the ISO 22101 series, this document is applicable to PE-sGF fittings, and to joints with components of PE-sGF or other materials, intended to be used under the following conditions: a)      a maximum allowable operating pressure (PFA) up to and including 25 bar;1) b)      an operating temperature of 20 °C as the reference temperature. NOTE 1       For other operating temperatures, guidance is given in ISO/PAS 22101-1:2022, Annex A. This document covers a range of maximum allowable operating pressures and gives requirements concerning colours and additives. NOTE 2       It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national guidance or regulations and installation practices or codes. This document is applicable to fittings of the following types: —    electrofusion socket fittings; —    loose backing flanges and flange adapters; —    fabricated fittings (see Annex A). 1) 1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2. About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|